AGCO Allis-Chalmers

PIN, Shaft Tapered, 6-7/8" long X .875" OD. X .625" threads, 1.00" long threads. Orange paint in tough condition and lots of chips and scratches.

Spacer .38"ID x .54"OD x .75"W. Sold Individually. We combine shipping on orders. The website should do this automatically for you. If it doesn't, let us know and we'll get you fixed up or run the...

Sprocket 14T, Center hole .87"ID x 8.80"OD, sprocket teeth .65" wide. 500674 is casting number.

70500704 Housing Cast Metal with 3 outer holes

Allis-Chalmers Double GUARD These have replaceable ledger plate that is smooth, not serrated. Sold Individually.We combine shipping on orders. The website should do this automatically for you. If it...

Hanger BLOCK 2.25" x 1.75" x 1.00" Thick Large Single Hole .62"ID 2 Holes in side all the way thru the 1.75" Length  .25"ID on 1.25" Centers

Sprocket 7T, Has a tapped hole on one side for grease zerk. Overall width of hub is 2.80" wide. Sprocket sits in the middle. Casting Number C501725.

SPROCKET Clutch 12T, 1.25"ID x 4.80" OD, overall width 1.75", slip clutch has 4 cogs, 3.00"OD of cog hub, casting number 502319.

In the books as "Special Rings" 2.440" Housing x .062"T x .125"W All Retaining/Snap RING spec's come from an AGCO Quick Reference Book. I try to validate these specs to the actual part before listing...

Sprocket 10T, square hole .77" X .77" ID, overall width 1.00" x 4.20"OD. Casting number 502343.

70503916 AGCO ALLIS-CHALMERS HOUSING

LEVER Brace Support Connector Bar 34.75" long X 1.25" wide X .38" thick. Three holes, Two are .37" ID. One hole is .25" ID. Paint is fair, areas of rust.

SPRING, Compression Spring, .43"ID x .56"OD x 1.79" Long x .066"OD Wire Sold Individually.

Sprocket 12T, .75"ID x 5.00"OD x 1.50" wide with hub. .25" keyway. Casting number 3202AC.

Sprocket 12T, .87"ID x 6.75"OD. 505593 cast number,

Sprocket 15T #60 x 1.12"ID x 4.00"OD x 1.76" Wide Hub with .25" wide Keyway. Casting number 505597. 70505597 supersedes to 70515824 . This is part number 70505597.

Sprocket 12T .75" ID x 5.12"OD x 3.00" wide including hub.

PULLEY Two Piece. Bolt holes are .27"ID on 3.37" center. The belt area is 2.00" x 6.87"OD Overall width is 2.62".

POINT, DIVIDER, Cast Metal. 3 holes in bottom, 1 hole top. 6.50" long x 2.80" wide x 3.50" tall. No casting number. Paint is weak and some surface rust. Item pictured is what you will receive. New...

PIN, Latch Pin .19"OD Wire