CNH New Holland

Spacer, split wall. .52"ID x .69"OD x 1.25"W. Sold Individually. 34025 Replaced by 87647650.

LATCH Plunger, New Holland NH Model S77 NH Baler.

BEARING ASSY Support with bushing. 6.25" x 2.25" w/zerk, 2 slotted holes .31"W x .84"L on 4.50" centers. Applications: S77, 87, 98 New Holland Small Square Balers.

SHIELD Feed Arm Cover. 4-1/8" X 3.00" X 1-5/8". New Holland Models S77, 87, 98.

GEAR, w/Bushing, Clutch, Knotter, with 2 grease zerks. S77

ARM with grease zerk. Part Number 34500 ink stamped and casting number 34500. New old stock OEM New Holland 34500.

PIN Shaft Connecting Rod Plunger, Rear . Related part 1075 Sleeve. Application: New Holland NH Super 77, S77 Baler. 34516

Wear, Bracket, Knife, LH 5-3/8" X 3" X 1/2".  1 hole beveled 3/4" ID. Opposite 34550 Sold Individually.

Feed Arm Yoke Bearing Assy with Bushing Support w/ grease zerk. Bushing ID 1.12". NH Models S77, 87, 98 Balers. Vintage OEM New Holland part number 34551. Sold individually.

Shaft w/ cross hole.    .75"OD x 10.50"L. Tapped in one end 5/16"-16 Female. 87 - NH SQUARE BALER(05/55 - 07/57) WADBOARD, WADBOARD BRACE POST & WADBOARD LINKAGE98 - NH SQUARE BALER(04/57 - 02/60)

ADJUSTER Pickup Wheel Adjuster. Fits NH Model 66 Baler.

STOP Clip Clamp with two holes. 32125, 80034793 supersede to 34793. This is new OEM New Holland part number 34793. NH Models 66, S66, 166.

Stud. 3.25" long. Male threads on each end.

OEM New Holland Right or outer end Guard.  Has a cutout in the lower RH corner. NH replaced this with a center style Guard 144176 and left it to the customer to cut to fit. Has replaceable Ledger...

350918 New Holland Bracket

RETAINING RING, Snap Ring, NH Shows Ext, 1.250" x .158" thick. 36313 Replaces 2974377, 548628R1, 80036313, 920304C1, A143425, A27012, H130351, O459FH1, O6090AB, R18875. 717 - NH PULL TYPE FORAGE...

SPROCKET and Hub, Single, #50 chain, 19 teeth; 1.36"ID x .37" wide keyway x 5.00" wide overall. Hub has 2 setscrews and lock nuts. Application: NH Models 818 and SP818, Engine Drive at Gearbox, 020...

HANDLE Lever Arm, Pin OD is .75". NH Models 55, 55S Rakes.

Bar Tension for square baler. New Holland has "washer" in some of their descriptions. NH Models S77, 87. Has been mounted by looking at mounting holes. 22-1/8" x 3.50" x 2.75"

Pivot Yoke COLLAR Support Cast Metal with 2 ears / pins.